Advice : Before calling an engineer please check how old your HOTPOINT is, If your machine is under 5 years old it could have a free parts warranty with HOTPOINT, so call HOTPOINT unless...

Indesit repair problems and fixed prices.
Includes Parts labour guarantee and safety check

• Washer won't spin. (motor brushes) Fixed fee £73.50
• Indesit washer won't drain fixed fee £73.50
• Washing machine door seal split £78.00

Indesit Tumble dryer
Includes Parts labour guarantee and safety check

• no heat £73.50-£88
• not rotating £73.50

• No heat £83.50
• Indesit oven Over Heating £98
• Not hot enough £98
• Hinges £98

Indesit Cooker fixed problems resolved
Includes Parts labour guarantee and safety check

• No heat £83.50
• Indesit oven Over Heating £98(thermostat)
• Cooker Not hot enough £98
• Hinges £98

If your appliance is deemed to be beyond economical repair then there will be a charge of £30 for time taken.

Indesit Error Messages and Error Codes

• F10 - No cold fill. Check that the taps are on or if the drain hoses are kinked.
• F11 - No hot fill.The ambient temperature is likely to be below freezing possibly due to the pipes being frozen. Also check that the taps are on or if the drain hoses are kinked.
• F12 - No mixed fill. It is likely that the water is not turned on at the taps.
• F13 - Check the water supply, inlet valve and hot and cold hose connections.
• F14 - A fault with the water heating has occurred.
• F15 - Water is not being pumped out and a flood condition could occur. Check that the drainage hose is raised to the recommended minimum height and that the pipe is not blocked.
• F16 - Extremely high water level Disconnect or turn off the water supply and ensure that the water level does not rise any more. Then
• F17 - Door not closed properly. Close door firmly at the 3 o'clock position.
• F20/1 - The thermistor resistance has drifted or the temperature scanning sequence is incorrect. The ambient temperature could be below freezing
• F30/31 - A motor drive problem has occurred. Try running the programme again. If the problem persists book a service engineer.
• F40 - Water below protection level during a heat step
• F41 - Water level detect sequence incorrect
• F50/51 - Customer language and wash programme have not been saved. The system will run with default conditions (1000rpm max and English language). Book a washing machine repair to re-programme your product.

Fault codes for Indesit LCD EVO1 Washing Machines and Washer Dryers

• F01 - Short circuit motor triac
• F02 - Motor jammed tacho detached
• F03 - Wash thermistor open/short circuit
• F04 - Pressure switch jammed on empty
• F05 - Pressure switch jammed on full
• F06 - Program selector error
• F07 - Heater relay stuck
• F08 - Heater relay cannot be activated
• F09 - Incompatible eeprom
• F10 - Pressure switch not sensing correctly
• F11 - Pump cannot be activated 
• F12 - Communication error
• F13 - Dryer fan or dryer thermisotor faulty
• F14 - Dryer element faulty
• F15 - Dryer element relay faulty  
• H20 - Not fillings. Check tap, hose and inlet valves
• LOCKED - Check interlock

Fault codes for Indesit LCD EVO2 and V4 Washing Machines and Washer Dryers

• F01 - Motor traic short circuit -
• F02 - Motor jammed or tacho detached
• F03 - Wash thermistor open/short circuit
• F04 - Pressure switch jammed on empty 
• F05 - Pressure switch jammed on full . 
• F07 - Heater relay stuck
• F08 - Heater relay stuck
• F09 - Setup error
• F10 - Pressure switch not sensing
• F11 - Pump cannot be activated
• F12 - No communication between cards
• F13 - Drying thermistor open/short circuit
• F14 - Drying element faulty
• F15 - Dryer element relay fault
• F17 - Interlock error
• F18 - Communication error
• H20 - Not filling. Check tap, hose and inlet valves

Indesit Fridges and Freezers

• F1 - Freezer thermistor open circuit.
• F2 - Freezer thermistor short circuit.
• F3 - Fridge thermistor open circuit.
• F4 - Fridge thermistor short circuit.
• F7 - Evaporator thermistor open circuit.
• F8 - Evaporator thermistor short circuit.
• F9 - Temperature set switch open circuit
• FA - No feedback from Baffle
• FB - Fridge Baffle motor operating continuously.
• FE - Defrost time out.

Indesit Dishwashers

• F10 - Fill or empty time out. Check that the hoses are not kinked, that the taps are on or whether the drain pump or     hose is blocked.
• F11 - Heater timed out. The heater has not reached the required level.
• F20 - Temperature under range.
• F21 - Temperature over range.

Fault codes for Indesit LCD Dishwasher Models

• A01 - Float switch operated
• A02 - Open/Short circuit heater relay -
• A03 - Short circuit on thermistor or Time-out drain- Check filter for blockages then book a repair if the problem persists.
• A04 - Unable to reach or sense temperature within 70 minutes -
• A05 - Pressure switch has not been reset
• A07 - Open/Short circuit wash motor triac
• A08 - Open/Short circuit auxiliary wash motor triac
• A09 - Open/Short circuit with main wash traic -
• A10 - Open/Short circuit fill valve traic
• A11 - Half load valve traic or alternating motor action -
• A12 - Open circuit heater rely
• A13 - Open/Short circuit dispenser traic -
• A14 - Drain hose too low causing syphoning. Check drain hose and re-adjust.
• H20 - Check tap and pressure of incoming water.

Indesit  Tumble Dryers

• F1 - The level of required dryness has not been reached within the time period. Check that the correct programme has been selected
• F2 - Thermistor or sensing circuit failure.
• F3 - Heater plate over temperature. Check the filter and vent hose for a possible blockage.

Fault codes for Indesit LCD Tumble Dryers

• F01 - Short circuit motor traic
• F02 - Motor jammed or fan blocked
• F03 - Front thermistor open/short circuit
• F04 - No pump piloting
• F05 - No feedback from the pump
• F08 - Static heater relay with contact welded closed
• F09 - Eeprom is not programmed or not functioning
• F10 - Common of heater open or one shot open
• F11 - No pump connection
• F12 - Communication error between boards
• F13 - Rear thermistor open/short circuit
• F15 - Dynamic heater relay with contact welded closed
• F-17 - Master relay welded closed

Washing Machines, Tumble Dryers, Dishwashers,
Cookers and Ovens Repairs

Welcome to the Appliance repairman site. We are specialists in Laundry & Kitchen appliance repairs for all major brands,
Including but not limited to AEG,Ariston, Beko, Belling, Bosch, Creda, Indesit, Neff & Siemens employing the very best engineers in the industry to repair your problem appliance.

Just £49
Includes all required labour, callout, diagnosis and safety check.
(Bosch Neff & Siemens Diswashers £58-£68 Built-in)

48 Hrs
We aim to have your Appliance repaired within 48 hours. or we give you £5 Off

Time Slots
We offer convenient times Before 1 after 1 or an hours notice.

Payment
All major debit & credit cards accepted, cash & cheques not a problem either we also take Nochex & Paypal, no payment taken at booking.

Office Hours
8:30am - 6:00pm Mon-Fri    9:00am - 1:00pm Sat

Below are some of the major brands we offer fixed price repairs for whether it be your Washing machine, Oven, Hob, Cooker, Tumble Dryer or even your poorly Dishwasher.