Appliance Repairman Tips & Advice

Indesit washer timer constantly turning and nothing happening!

admin — Tue, 09 Aug 2011 14:00:24 +0000

Indesit washer timer constantly turning and nothing happening!

This problem is normally down to a blocked filter, so check your outlet filter (located bottom right under flap)

WARNING. water will come out be prepared!

If full, empty and reset appliance:

set control dial to stop or the dot, turn on for 1 sec then turn off for 6 secs (repeat 3 times)

if doesn’t cure prob and continues to react by dial turning, could be another fault.

service engineer required, other possible probs:

heater
pump
motor
interlock
presure stat
thermal over load

regards

richard saupe

appliance engineer for over 10 years!

call if in Essex 01206 43 43 43

Problem with a Bosch Washer Not Spinning or Draining

admin — Tue, 15 Jun 2010 10:33:21 +0000

Everyday , I get a few people call my repair company aaa repairman.com telling me their washer is not draining or spinning. Wow, it is so obvious to me what is wrong, just a simple process of elimination. I never thought on my repair training course, that the tutor was actually right! He said the customers will call you(providing you do the right sort of marketing) and tell you what is wrong with their machine. Dah No way I thought! If they tell me what is wrong with their machine, why the heck are they going to pay me to fix it. It’s simple really even though most people know what is not happening they don’t know what is the cause. So bare with me and I’ll let you know a few trade secrets.. 1, when a customer says their machine is not draining or spinning: this is code for a pump failure or blockage: reason: A machine can not spin when it is full of water. the manufacturer has installed a safty feature that will not let the machine spin unless it is empty, it is called the pressure system it is a simple device comprised of a plastic tube and a diaphram. Solution : replace the pump or remove debris obstructing the movement of impellor. £price for repair from £45-£90 depending on repairer and part cost. Not Spinning is another common problem but the drum has to be empty. If it is empty of water then it means. You need to check if drum turns manually, just stick your arm in the drum and give it a turn if it spins freely for a few revolutions then the belt is off. Was the machine noisy before it stoped spinning If so this means it could be the bearings. turn the drum again and listen for a rumbling noise. if it is quiet hold one of the paddles and turn the drum firmly pushing slightly on it and feel for vibration. it could be that the belt has stretched and come off. incidently this only happens on certain zanussi,electrolux,AEG and tricity. You will just need to replace belt. Belts do wear out, but typically nowadays your belt will out last the machine. they should last about 10 years or so.. Ok we’ve decided the drum turns but only a quarter to half turn unless I push hard then maybe one turn. THis is normal the drum is restrained because of the friction caused by the belt and motor. Another common problem with washers not spinning is due to the brushes/carbons wearing down on the motor. basically if the brushes/carbons don’t touch the commutator or armiture then the current can’t flow through it to give rotation. This fault will typically happen if a machine is 5 years plus old and used 4-5 times a week if thit has happened sooner YOU ARE OVER LOADING it. Solution: replace brushes/carbons Costing: depending on machine parts and repairer £35-£98 WORDs of advice if you have a bosch neff or siemens washer that is 5-7 years old and you use 4-5 times a week. get it serviced by a professional repairman company.Service = Pump & Brushes this could add 3-5 years to machine.. Another funny problem I’ve come across with Bosch Neff & Siemens washers is that if a 5p gets stuck in the filter housing it can sound like the drum bearings are on there way out. remedy clean filter out regular. Loading a washer any washer.. only half fill the drum. I can hear you say it there is more room or only one more pair of jeans or I haven’t got time to wait for another load or I KNOW MY MACHINES CAPABILITIES! Carry on then, would you like to pay for the extra repair now or later. You see by over loading your machine you’re creating more wear and tear on the motor, bearings drain pump and structure of the washer. almost everything in a machine is compromised when you overload it So please only do it if you can afford too. Oh I have to tell you this problem THE soap dispencer/draw won’t take conditioner. Ok this is because you fill it too high with conditioner. Take out the draw and look at the roof of the now empty compartment. it will be black with mould. get a dentist pick and a tooth brush and a sprayer and clean it. another trick you can safely USE.. My machine door seal is black and dirty. this is normally caused by funghi build up. caused by using liquid detergent( they have no bleaching agent in them. try using powder. My machine is smelly like the sewer. get some white vinegar 500ml to 1000ml and put in the drum of your machine on a 60-90 degree wash. Fingers crossed This will hopefully neutralise the smelly bacteria.

Disclaimer Richard Saupe the copyright holder of this written advice 2009 in no way takes any responsibility for any untrained person taking his advice in any way shape or form. please beware that a washing machine to the untrained can be a very dangerous piece of equipement. ALways disconnect before attempting any DIY repair, but this on it’s own, will not guarantee you against harm. Be careful very careful If in doubt call a professional. Let them assume the risk on your behalf.. Warmest regards Richard Saupe engineer, entrepreneur inventor and franchise holder of www.aaarepairman.com telephone 0800 44 88 999 Covering Essex and Suffolk and parts of east London Head Office Colchester

Bosch Washer & Oven Common Domestic Appliance Repairs !

admin — Tue, 15 Jun 2010 10:31:43 +0000

Washer won’t drain? Check the filter & outlet hose for blockages! it may be the Pump. Washer won’t spin This can be as simple as a belt off or new brushes fitted to motor. but can also be that the machine has water in it. also Motor or timer problem washer gets stuck on different points Timer faulty or one of the parts Cooker no heat Probably Element. Cooker over heating thermostat Oven Not heating up enough Check Fan is working Oven cuts out when gets hot Cooling fan or temp limitor Tech Support Richard Saupe 07956490722(support not booking) www.apliancerpairman.co.uk

Bosch Washing Machine Eco Logical, is it really Eco?

admin — Tue, 15 Jun 2010 10:30:57 +0000

It’s A complete myth that you can make a washing machine ozone friendly and environmental and Give it a tripple A (AAA) rating or even a C rating. then give it to a human being! I’ll Explain, washing machines with the correct load may be A efficiency, but who knows or if they do know who bothers to follow manufacturer guidelines when it comes to loading a machine. Most people are in such a hurry they just ram the drum full of clothes, then force the door closed. overloading the drum will shorten the life span of your machine by upto 50% or more you will strain the drum, drum support, bearings and you will draw more power through the motor thus wearing that out too. The average machine can last between 5-7years but we as engineers are seeing machines being distroyed within 2 years. and this is mainly down too people overloading the machine. Machines are meant to emulate going down to the local stream and bashing your clothes up against the rocks this works to push the soap through the clothes not sit on them. if you overload the machine you’re not only killing the machine but you’re not washing your clothes either. You will see white marks on your black clothes. this is very common powder mark, the effect of overloading. hope this has been useful regards Richard Saupe appliancerepairman.co.uk

Oven blowing cold air or not heating up or tripped Electric!

admin — Wed, 24 Feb 2010 10:26:22 +0000

These are common issues we get called out to repair “Oven blowing cold air or not heating up or tripped Electric!”

they all have a common denominator, it is the element that has either failed or blown.

Simple resolution is to replace the element in most circumstances.

A trained engineer will be able to do an insulation/ safety check to find out which element has blown.

Fixed fee by our engineers is £83.50 for a new fan element!

warmest regards
Richard Saupe

Appliance repairman Ltd
0800 44 88 999
07538538138
we service and repair most brands
repairs and sales of cookers, ovens, washers
Repairs and sales for Bosch Neff & siemens Cookers, Ovens, diswashers & washing machines

Bosch Oven Not Getting Hot Enough!

admin — Wed, 24 Feb 2010 10:14:23 +0000

Bosch Neff and Siemens (all makes really). Stop becoming effiecient when the fan stops rotating, this is due to the thermostat being placed next to the circular element.

The fan forces air to pass through the element and over the thermostat capillary thus not activating it untill the whole oven has reached the desired temperature.

So if the fan staps working then there is no forced air to keep the thermostats temperature down so it heats up and activates very quickly!

Your oven might reach a constant temp of about 120-140 but that is it without the fan working.

Appliance repairman ltd have a fixed fee of £141 for Bosch Neff and Siemens Fan Oven repairs(includes labour and Parts) other makes vary from £98

warmest regards
Richard Saupe

Bosch, Neff & Siemens washers not taking conditioner

admin — Wed, 24 Feb 2010 10:05:48 +0000

My conditioner does not get taken!

If this is a problem, the common cause is a build up of black mouldy conditioner on the top of the drawer compartment.

you can try cleaning with cotton buds / tooth picks and anti bacterial spray.

You will notice as you clean that there are 4 square holes under the black mould, these need to be cleaned!

If you have a problem with this you can call on Us to do it, we strip the machine down and take the drawer apart clean then replace.

we have a standard fix fee of £49 plus any parts.

warmest regards
Richard Saupe

Appliance Repair Man Launches New Site

admin — Mon, 22 Feb 2010 02:16:54 +0000

Appliance repairman launches another repair blog link with Saupe.co.uk

We will have low cost reconditioned machines here aswell as special days with special discounts.

To have your appliance repaired call 0800 44 88 999

Fast and friendly washing machine cookers ovens dishwasher(bosch neff and siemens only) and tumble dryers repairs…

warmest regards
Richard Saupe
Director Appliance repairman ltd
01206 434 999 | 01473 396 999 | 01702 911 999